Google+ sitemap

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Pacific Security Systems in Mumbai, India
 

Honeywell Fire Alarm System

   
Repeater Smoke Detector
Honeywell Fire Alarm Panel Addressable Manual
Call Point
Addressable Loop Sounders
Addressable Control Module Addressable Monitor Module  
 

Heat Detector

 
Heat Detector
heat detector
 
The Fire-Lite Alarm H355 Series thermal detectors are addressable sensors that use a state-of-the-art thermistor sensing circuit for fast response. These sensors are designed to provide open-area protection and are intended for use with Fire-Lite's MS-9600 and MS-9200UD Fire Alarm Control Panels (FACPs). Both the H355 and H355R sensors provide fixed temperature alarm detection at 135°F. The H355R sensor responds to rate-of-rise conditions of greater than 15°F/8.3°C per minute. H355HT provides fixed high-temperature detection at 190°F/88°C. These thermal detectors provide cost effective, addressable property protection in a variety of applications. Two LEDs on each sensor light to provide a local, visible sensor indication. Remote LED annunciator capability is available as an optional accessory
Features
    SLC loop:
  • Two-wire loop connection.
  • Unit uses base for wiring.

    Addressing:
  • Addressable by device.
  • Direct Decade 01-99 (MS-9200, MS-9200UD) and 01-159 (MS-9600) entry of address.

    Architecture:
  • Sleek, low-profile, stylish design.
  • State-of-the-art thermistor technology for fast response.
  • Integral communications and built-in device-type identification.
  • Built-in tamper resistant feature.
  • Built-in functional test switch activated by external magnet.

    Operation:
  • Factory preset at 135°F (57°C).
  • Rate-of-rise model (H355R), 15°F (8.3°C) per minute.
  • 360°-field viewing angle of the visual alarm indicators (two bicolor LEDs). LEDs blink green in Normal condition and turn on steady red in Alarm.
  • Visible LEDs “blink” every time the unit is addressed.

    Mechanicals:
  • Sealed against back pressure.
  • SEMS screws for wiring of the separate base.
  • Designed for direct-surface or electrical-box mounting.

 
 
      | |